Written By: macro (and one other contributor)
Published: May 23, 2024
- Comments: 0
- Favorites: 0
- Views: 409
Written By: macro (and one other contributor)
Published: May 23, 2024
- Comments: 0
- Favorites: 0
- Views: 409
Teardown
Introduction
Get to that gross area in that back of your countertop ice maker for cleaning.
What you need
This teardown is not a repair guide. To repair your Countertop Ice Maker, use our service manual.
-
Step 1 safety first
-
Remember that ice makers contain toxic refrigerant. Hand and eye protection are recommended
-
A medium phillips-head screwdriver is also required
-
-
Step 2 unplug and drain
See AlsoRobot or human?How To Clean An Ikich Ice MakerRobot or human?How to Clean Your Portable Ice Maker: 10 Steps (with Pictures)-
unplug your countertop ice maker
-
place over the sink and pull out the rubber stopper from the bottom
-
wait for all fluid to drain
-
-
Step 3 remove back housing
-
Once drained, place ice maker on its side. Remove the highlighted screws that hold the back plastic cover in place.
-
Then remove the black plastic cover.
-
-
-
Step 4 remove top housing
-
remove the screws holding the top cover in place.
-
Don't forget the other side!
-
-
Step 5 remove tray motor and water intake
-
remove two screws holding the tray motor in place. Then pull the tray motor straight out. It may require a bit of force if rust is sticking it onto the tray
-
remove the water intake hose by pulling it straight down
-
-
Step 6 remove side panel wires
-
uncover the electronics by unclipping the specified points
-
unplug the wire connecting to the right side panel
-
-
Step 7 remove side panels
-
remove the screws holding the side panels in-place
-
unscrew the refrigerant pipes from the side panel
-
carefully remove both side panels
-
-
Step 8 remove ice tray
-
at this point, the ice tray should be freed up for removal (and cleaning)
-
Author
with 1 other contributor