How to stop my LED strip lights from falling down? | LED installation advice (2024)
3M backing tape
All of our LED strips have 3M backing tape fitted as standard, at InStyle we use the strongest 3M backing available. This is great if the strip is being stuck on its back, with the LEDs facing the ceiling (upwards). If the LED strips are on their side or on the ceiling facing downwards, then eventually they will fall down and you should consider one of the additional fixing options below. Always make sure the area is flat and as clean as possible before sticking LED tape into place with 3M self-adhesive backing.
Our foam backing tape is seriously sticky. This is great for splashproof LED tape, that weighs a bit more than normal tape. It is also ideal for areas that are not completely even or not as clean, as the foam tape will stick better than the standard 3M backing. Another tip is to stick the foam tape into place and then stick the LED strip with its standard 3M tape attached onto the foam tape, because foam tape offers an ideal surface to stick to. Again if the strip is on its side or facing downwards, be sure to use one of the options below.
Fixing clips are a great way of keeping the strip into place, the only negative is you need the time to screw them into place and a little extra space around the LED strips (the clip’s additional width). The clips are a long-lasting install that won’t come down until you choose to take them out. Fixing clips are ideal if the strips are facing downwards or to the side or facing upwards, in any position. These are also a good choice for external strips, where the backing tapes will not work.
Extrusion
Our aluminium extrusions are a great way of keeping your LED strips into place. Their inner surface works extremely well for LED tape to stick to using the standard 3M tape, and there’s also a cover to protect the the tape. The extrusions can be directly screwed into place or fitted using fixing clips that the extrusion snaps into. The extrusions are ideal internally or externally, and add protection for the LED strips. They can be installed any any angle, e.g. facing downwards
Why InStyle LED?
We stock all of our LED tapes for next day delivery.
You can provide us with any sketches / plans, and we can advise on the most cost effective approaches for wiring / control.
We can speak to any installers, before, during and after your project to answer any questions.
Please call us today on 0116 2799083 or emailsales@instyleled.co.uk
Silicone glue has good thermal conductivity(0.27W/MK), which can help heat dissipation of the led strip and prolong the lifespan of the led strip. Silicone glue has excellent UV (ultraviolet) resistance and can be exposed to strong sunlight for a longer period of time without yellowing and aging.
If the LED strips are on their side or on the ceiling facing downwards, then eventually they will fall down and you should consider one of the additional fixing options below. Always make sure the area is flat and as clean as possible before sticking LED tape into place with 3M self-adhesive backing.
Use mild detergent or alcohol wipes to remove any oil, dust, or grime. Test adhesive quality: Test a small section of the LED strip on the intended surface beforehand to see if it sticks well. If not, buy a stronger adhesive or choose a different location for the lights.
This glue is perfectly safe to use on single LED lights and is a fast acting adhesive that dries clear. Super glue has excellent holding properties on a variety of different surfaces making it a great choice for modelers and hobby enthusiasts.
You will require a hot glue gun, a heat gun, and some clear heatshrink. Begin by putting an amount of hot glue on the cut end of the LED tape or at the cut point which needs waterproofing, and then slide the heatshrink over this.
Introduction: My name is Chrissy Homenick, I am a tender, funny, determined, tender, glorious, fancy, enthusiastic person who loves writing and wants to share my knowledge and understanding with you.
We notice you're using an ad blocker
Without advertising income, we can't keep making this site awesome for you.
